LED mounting strips for M5 Faceted Lens
These strips were designed from The Original MegaTree Strips for those using LED light strings. These allow you to place lights at 1" centers and maintain a uniform spacing in not only MegaTree designs, but any application that requires the nodes to be installed in a vertical orientation.
Our MegaTree Strips provide that missing link to making a clean and straight MegaTree in only a fraction of the time compared to past methods. No more measuring spacing and taping or using zipties to attach each light to banding material or spending hours drilling holes into expensive PVC pipe. With our mounting strip you simply snap in a light and you are done. Most people can install a 50ct string in 1-2 minutes. It's that fast!
Our strips have endured the cold winters of the northern United States and Canada to the extreme heat of Australia and performed flawlessly. We have documented wind speeds of 30+ MPH winds on our 40' MegaTree and we have testimonial from clients that had wind gust up to 75 MPH. The strips are design to withstand the harsh environments of winter time decorating.
The strips can easily be extended to any length simply using 4" zipties and the provided 1/8" securing holes that are located on both sides of the strip in 1" increments. You can use other common fasteners such as screws, rivets, and bolts if you need to mount to wood, fascia boards, and other structures. We also have the MISR Clip that can be used at the top and the bottom of your strips so you can apply extra tension on your strips.
At the end of the decorating season, you can simply roll the strips up with the pixels still attached and store them in a plastic tote or hang the on a wall. The strips will be ready to go for the next decorating season.
- Available in both Black and White
- About .04" thick
- Custom blended High Density Polyethylene (HDPE) plastic
- UV Inhibitor added to maintain flexibility and to prevent brittle or chalky plastic
- Each strip is 95.5" long with 95 mounting holes
- Mounting holes are at 1" centers
- Splice holes are provided at 1" centers
- Customizable with a pair of scissors, just cut to any length
- Easy in and out feature to make strips and replace defective nodes